Arcam P-7 high performance 7 channel amplifier

$5,000.00 $1,989.00

FMJ P7 7-Channel Surround Amplifier – Technical Specifications

All specification shown below are typical, unless otherwise stated. Please note that Arcam’s policy is one of continuous improvement. We therefore reserve the right to change the material, dimensions, specifications or design of our products shown or referred to herein at any time and without prior notice. Illustrations used in our leaflets or on our website are intended as a guide only. E&OE 10/03.
All measurements are with 230V / 50 Hz mains power
Continuous Power Output
Watts Per Channel: All channels driven
20Hz – 20Hz, 8ohms, 150WPC
1.05kW total
20Hz – 20Hz, 4ohms, 230WPC
1.62kW total
Watts Per Channel: All channels driven
8ohms, 160WPC
4ohms, 230WPC
3.2ohms, 300WPC
Peak Output Current Capability
>22 amps per channel

Total Harmonic Distortion
At any level up to rated power, into 4 or 8 ohms
<0.05% 20Hz – 20Hz, typically <0.005% at 1kHz
Frequency Response
+/- 0.2dB 20Hz – 20Hz
-1 dB at 1Hz and 100kHz
Residual Hum and Noise
Typically -112dB ref full power
Voltage Gain
X28.3 (1 volt input gives 100W / 8 ohms output)
Input Impedance
22 kohms in parallel with 470 pF
Output Impedance
50 milliohms at 20Hz, 1kHz 120 milliohms at 20Hz
Power Requirements
115 or 230 VAC, 50 / 60Hz, 3kW maximum via heavy duty IEC mains inlet.
A soft start system eliminates large currents at switch on.
General
Dimensions W/D/H mm. inc. feet. 433x460x180
Weight (packed) 35kg
Category:

Description

Floor Demo