Stillpoints Component Stand SS
This product may take 3 to 5 business days to fulfill.
The Component Stand SS is the Stillpoints answer to those audio systems requiring the remote placement of
stereo or mono block amplifiers too large to place in a standard rack. The Component Stand SS can also be
used to support individual components at floor level should that be a preferred system setup approach.
As an example, using the Component Stand to support mono block or stereo amplifiers allows placement of
these components closer to loudspeakers. Closer to the loudspeaker means shorter speaker cables.
The stainless-steel (SS) Component Stand frame is available in three leg or four leg versions, in both nine-
and eleven-inch leg lengths. The Component Stand is to be used in combination with the Ultra product of your
choice: Ultra Mini, Ultra II, Ultra SS V2, Ultra 5 V2, or Ultra 6 V2.
The robust stainless-steel frame design allows components of high mass to be supported easily. Many other
stands or platforms designed for this use are made of large square or rectangular plinths. These stands, with
large surface areas, are subject to becoming resonant diaphragms themselves, absorbing and reflecting
airborne and mechanical vibration.
By comparison, the Component Stand SS is a strut like structure with little surface area to be affected by
resonance. The open design of the Component Stand SS also allows airflow to circulate and cool the
Tuning of the stand to your component is one of the strengths of the Component Stand SS. The legs can be
rotated around a central hub to accommodate components of multiple sizes. Within the frame, you can move
the Ultra filtering devices along the rail system in each leg.
Adjusting the location of the filter along each rail allows you to determine the best position to both support the
component and maximize the filtering of vibration borne resonance for best fidelity. This system allows
components to perform at a maximum of their potential.
After the success of the original component stand, Stillpoints has done over ten years of research and
development before releasing the "NEW" Component Stand SS.
The Component Stand SS is a great design that illustrates how one uses any Stillpoints isolator. Bypassing the
components original feet, making contact with the bottom of the chassis to come in direct contact with the
micro vibrations that are generated by the electrical current running through the devices on the circuit board
and following the circuit board standoff down to the chassis’ bottom